VEICHI — SD700 User Manual 20230516

3. Linear drive output circuit The following describes the 33-34 (phase A signal), 35-36 (phase B signal), and 19-20 (phase C signal) terminals of the CN1 port. The output signal (PAO, /PAO, PBO, /PBO) and the origin pulse signal (PCO, /PCO) of the encoder's serial data are converted into two-phase (A-phase, B-phase) pulses and output through the line driver output circuit. On the upper device side, please use a linear receiver circuit.

62 SD700 Series Servo Technical Manual Servo motor /BK ALM /S-RDY and other output terminals DC24V RY Emergency RY button 电机 Motor + DC24V Surge - absorber Breaker Enconder Brake winding dedicated power supply Using a linear receiver is PAO equivalent S N 75ALS175 220 Ω ~ 470Ω PAO- PBO PBO- PCO PCO- GND GND Please connect shielded wire according to the FG requirements of the Shelter wire equipment PAO PAO- PBO PBO- PCO PCO- GND FG Using a linear receiver is equivalent S N 75ALS175 GND Please connect shielded wire according to the requirements of the equipment 220 Ω ~ 470Ω