VEICHI — SD700 User Manual 20230516

3.14 Torque Control Wiring Diagram ( Speed command input Battery of absolute encoder Max input voltage: ± 10V 3.2V ~ 4.5V ( Torque command input Max input voltage: ± 10V A phase of encoder pulse division output pulse division output B phase of encoder receiver: Linear SN75ALS175 pulse division output C phase of encoder or T.I.

company MC3486 of Control mode switch input (valid while ON) Zero (Valid while ON) - position fixation input Servo ON Input P operation command input (Servo ON while signal ON) (P operates while ON) Forbid FWD driving input (Forbidden while OFF) Max Forbid REV driving input (Forbidden while OFF) voltage of optocoupler Alarm reset input (Reset while on) output DC 30V Max : ( According to torque limiting Torque limit selection current: DC 50mA mode ) *1. is the twisted shields. FG Shields are connected to connector shell Frame grounded *2. DC24V * 3 . Connected while using absolute encoder. But never connect backup battery while using encoder cables with battery unit.

power should be prepared by user. And double insulation or reinforced insulation equipments should be used for DC24V power. *4. Note: While using 24V braker,DC24V power should be separated from the power for input and output signal (CN1). Please prepare otherwise, there may be misoperation of input and output signal while power on. Output signal should be received by linear receiver.

other power individually, 65 SD700 Series Servo Technical Manual V -REF D/ A SG CN1 5 21 6 22 A/ D 9 0 33 34 47 35 36 19 20 38 39 40 1 41 25 42 26 43 27 28 44 29 30 45 31 32 Connector shell *3 BAT(+) BAT(-) /PP AA OO A pul PBO B /PBO pul PCO C /PCO pul SG Signa S -RDY+ Servo re S-RDY- while re COIN+ Positio COIN- (ON wh /V-CMP+ The spe /V-CMP -(ON wh ALM+ Servo ALM-OFF w D/ A T -REF D/ A SG 1 D/ A *2 +24V +24VIN /C-SEL /ZCLAMP /S-ON /P-CON /P-OT /N-OT /ALM-RST /TLC g 6 9 A/ D 38 39 40 41 42 43 44 2