VEICHI — SD700 User Manual 20230516

To prevent mutual noise interference between the servo unit and its peripheral devices, the following measures to prevent noise interference can be taken as required.  Set the input command device and noise filter as close to the servo unit as possible.  Be sure to connect a surge suppressor to the coils of relays, solenoids, and electromagnetic contactors.  Do not use the same bushing for the main circuit cable and the input/output signal cable/encoder cable, and do not bind them together. When wired, the main circuit cable and the input/output signal cable/encoder cable should be separated by more than 30cm.  Do not use the same power supply as the electric welder or EDM machine.

Even if it is not the same power supply, connect a noise filter to the input side of the main circuit power cable and the control power cable when there is a high-frequency generator nearby. 70 SD700 Series Servo Technical Manual