VEICHI — SD700 User Manual 20230516

4 Trial Operation 4.1 Inspections and Notes before Trail Operation In order to ensure the safe and correct trail operation, please check the programs as below before that: 4.1.1 Conditions of the Servo Motor You need to check and confirm all programs as below, if there is any problem, please handle it properly before that trail operation  Are the settings, wires and connections correct?  Is there any looseness in each fastening part?  When you use servo motors with oil seals, is the oil seal damaged? Is it smeared with organic oil?  Is the brake released beforehand when it is a servo motor with a holding brake?

4.1.2 Conditions of the Servo Drive You need to check and confirm all programs as below, if there is any problem, please handle it properly before that trail operation.  Are the settings, wires and connections correct?  Is the supply voltage of the servo unit normal?  Is the driver status display interface free of warnings and alarms? 4.1.3 Installation  Install the servo motor and servo unit according to the installation conditions.  The servo motor may fall when it rotates, so be sure to fix it on the machine.  Be sure to leave the servo motor at no load. 4.2 JOG Trail Operation The trial run refers to the JOG operation of the servo motor unit.

The purpose of the single trial operation of the servo motor is to confirm whether the servo unit and the servo motor are correctly connected and whether the servo motor is operating normally. Confirm the following points before running: 1. The motor is in the enabled state and the jog operation is invalid during the operation. 2. We suggest that the load inertia is not greater than 30 times of the motor inertia, or it could possibly cause strong mechanical vibration. 3. The Pn500, Pn310, Pn311 parameters set JOG speed, acceleration and deceleration time. 71 SD700 Series Servo Technical Manual