5 Operation 5.1 Basic Functions 5.1.1 Quick Guide 5.1.2 Servo Enable and Over-Travel Setting Enable Set the servo ON (/S-ON) signal that controls servo motor electrification / non- electrification. Pin numbers can be configured by parameters Pn601 ~ Pn609, and are always configured effectively by parameters Pn610 ~ Pn612. See “Input Signal Configuration” for details. The internal enable of the servo can also be turned on by setting the parameter PN001 (internal enable switch) to 1.
Over-travel The over-travel prevention function of the servo unit refers to the safety function of forcibly stopping the servo motor by inputting a signal of the limit switch when the movement part of the machine exceeds the safe movement range. For rotating applications such as disc table and conveyor, the over-travel function may not be required. In this case, the input signal wiring for over-range is not required. ! 1. In the one way over travel state, commands in the opposite direction of over travel can be received. 2. In position control, when the servo motor stops due to over travel, the position deviation remains unchanged.
To clear the position deviation, a clear signal (CLR) must be input. Cautions 1. Signal Setting Pin numbers can be configured by parameters Pn601 ~ Pn609, and are always configured effectively by parameters Pn610 ~ Pn612. See “Input Signal Configuration” for details.
72 SD700 Series Servo Technical Manual Basic parameters quick guide Servo-enabled, Over travel Motor rotation direction Stop modes Setting parameters Pn601~Pn609 Setting parameter Pn002 Setting parameters For wiring details, see “sequence input circuit” Pn004/ Pn005 / Pn007 Electromagnetic brake Regeneration resistance Setting parameters Pn008/Pn009/Pn010 Setting parameters Pn012/Pn013 Overload Setting paT ro amrq eu tee rs l Pim n0it 50~Pn052 F cio rcr uw iti ”r ing details, see “sequence output F Ro er w isi tr oin g od ne nta ei cls ti, s ne e “Regeneration Setting parameters Pn015/Pn016 Setting pa ra (um ne dt ee rr vs P ltn a0 g4 e5 ~P n047 s r c o ” o ) Electromagnetic brake Setting parameters Pn008/Pn009/Pn010 For wir ing details, see “sequence output circuit” Regeneration resistance Setting parameters Pn012/Pn013 For wiring details, see “Regeneration Resistor connection” Settin Overload g parameters Pn015/Pn016 Torque limit Setting parameters Pn050~Pn052 Setting parameters Pn045 ~Pn047 (undervoltage) Motor rotation direct Setting parameter Pn002 ion