operation With adequate eye protection in place, plug the router motor in. While holding one of the Control knobs to insure that the bit is free of the workpiece, turn the switch on. Using two hands, one on the large knob the second on the small black knob, gently stroke the router bit into the workpiece. The /" stylus will guide from the master and the profile of the master will soon begin to appear in the workpiece. After sufficient material has been removed from the starting position, turn the router off, loosen the 3/8 bolt and rotate both work mounts 90° aga} n aligning with a straight edge. Repeat the above on all four edges of the work mount.
After the workpiece has been rotated 360 ° remove the large bit and step down to the next smallest ..... diameter bit and repeat the above process. Always re-set the elevation of the stylus in respect to the bit _-_z, when changing bits. \ BINATION SQUARE / Some intricate carvings may require a 45 ° orientation. This can be accomplished with the aid of a combination square. \ \ Note! When carving objects which are symmetrical, it may become difficult to tell front from rear. You may Wish to identify the starting edge of both work mounts to keep them in proper relation. \ -% \ \ \