TILT PLATE WING NUTS As the carving begins to take shape some undercut work may be necessary. This can be accomplished by loosening two wing nuts near the yoke tilt plate, titting the yoke assembly to the desired angle and then re-tightening the wing nuts. "Always turn the router off when pivoting the yoke or making any adjustment," After the object is nearing completion you may find it necessary to re-mount the master and workpiece in a vertical plane rather than horizontal. This witl allow the bit to contact the workpiece on the top and base sections of the carving that were inaccessible in the horizontal plane.
{3 0 © © \ After the object has been completely carved it can be finished in a number of ways, Some prefer the rustic hand carved appearance that results from the router bits while others prefer sanding by hand or with a small hobby too[. !9