© Installing Blade Guard 1. From the bag Iabeled "Guard" remove the following hardware: 1/4-20 7/8 X Socket Head 8 In Set Screw Truss Head Screw *2 Truss Head Screws, t/4-20 x 5/8" Long *2 Socket Head Set Screws, 1/4-20 x 7/8" Long 1/4 In,, External Lockwasher *4 Fiat washers, 17/64 x 9/16 x 3/64 *2 Hex Nuts 1/4_20 *4 Lockwashers, 1/4 ExternalType *2 Wing Nuts, 1/4-20 Q 1/4-20 17164 I°D. 1/4-20 Wing Nut *2 Square Nuts, 1/4-20 114-20 Hex Nut Square Nut Flat Washer 1 Spreader Support 1 Spreader Bracket 1 Spreader Clamp Spreader Support From among the loose parts find the following:
1 Blade Guard Spreader Bracket Items marked with asterisk (*) are shown actual size 2, Make sure the blade is all the way up and square with table, 3, Position spreader support on rod until it is even with the end of the rod. \ Blade Square With Table Even With Rod = i ........... 4 Assemble the 7/8 inch long set screws, nuts, lock- washers and washers to the spreader support bracket and slip the nuts into the slot in the spreader support, 5 Finger tighten only the hex nuts NOTE:
Be sure to put the socket head set screw through the slot shaped holes in the spreader bracket (see itlus- tration)_ This allows the guard and spreader to be Iined up with the blade Be sure the socket end of the set screw is at the hex nut end of the assembly, Holes Up Round Hole On Side - Leckwasher ex Nut --='_ 19