FULL ONE YEAR WARRANTY ON L,RAFTSNIAN STATIONARY TOOL If this stationary tool fails due to a defect in material or workmanship within one year from the date of purchase, CONTACT THE NEAREST SEARS SERVICE CENTER IN THE UNITED STATES and Sears wilt repair it free of charge. This warranty applies only while this product is in the United States. If this Table Saw is used for commercial or rental purposes, this warranty will apply for ninety days from the date of purchase. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. Sears, Roebuck and Co°, D/817 WA Hoffman Estates, IL 60179 .
.._ Safety Instructions For Table Saw Safety is a combination of common sense, staying alert and knowing how your table saw works,, Read this manual to understand this table saw Safety Signal Words WARNING: means if the safety information is not foUowed someone could be seriously injured or killed, DANGER: means if the safety information is not followed someone will be seriously injured or killed CAUTION: means if the safety information is not followed someone may be injured, Before Using The Saw WARNING:
to avoid mistakes that could cause blade tilt controls (See "Getting to Know Your Table Saw" section), serious, permanent injury, do not plug the table saw in until the following steps have been satis- factorily completed. . Review and understand all safety instructions and operating procedures in this manual.
* Completely assemble and align saw (See "Assembly" section) ° Learn the use and function of the ON-OFF switch blade guard, spreader, anti-kickback device, miter gauge, rip fence, table insert, blade elevation and , Review the maintenance methods for this saw (See "Maintaining Your Table Saw" section)), - Find and read all the warning labels found on the saw (shown below), m ® , WARNING 1, Read manual before using saw. 2. Wear safety gogglesthat meet ANSI Z87.1Standards, ' 3. DOnot reach around or over saw blade. 4. Keep blade guard downend In place for throughcuts. 5. Do not do freehand cuts. 6. Keep hands out of path of saw blade° 7.
When ripping,use push stickwhen fence Is set 2 Inches or more from blade. 8,, Know how to reduce therisk of kickback, See Instructions for ripping, 9. When rlpNng, use push block and auxiliary fence wher fenceIs set between1/2end 2 Inches from blade. Do not make dp cuts narrowerthan 1/2 ]nch_ l& Turn power off endwalt for bladeto stop before adjustingor servicing. 12o VoIts 3450 RP M E23417 1 t 5 Amp._ 60 Hz_ I Ph I0" Blade When Installing Or Moving The Saw Avoid Dangerous Environment.
Use the saw in a dry, indoor place protected from rain, Keep work area well lighted Use recommended accessories Consult the owneCs manual Ior recommended accessories, The use of o When using a table extension longer than t2" attached to any side of the saw, bolt the saw to a stationary sur_ face or prop up the outer end of the extension from the floor or bench top to keep the saw from tipping o Put the saw where neither operator nor bystanders must stand in line wilh the sawblade, To avoid injury from unexpected saw movement. .
Bott or clamp the saw to firm level surface where there is plenty of room to handle and properly support the work- piece (See "Assembly-Mounting Your Saw" section) ° Support the saw so the table is level and the saw does not rock improper accessories may cause risk of injury to persons ° To avoid injury from electrical shock, make sure your fingers do not touch the plug's metal prongs when plugging in or unplugging the saw, Never Stand On Tool Serious injury could occur if the tool tips or you accidentally hit the cutting tool Do not store anything above or near the tool where anyone might stand on the tool to reach them,