Making the handle: - Miter crosscut a piece of 3/4 inch thick plywood to shape and size shown: NOTE: The mitered comers can be any size that looks like the drawing (about 1-1/2" by 1-1/2"), Putting it Together 1-1/2"_._ /___ 1-1/2" 5" Using good quality woodworking glue, glue the 3/8" x 3/8" Ч 2-1/2" piece strip saved earlier to the base as shown, -_ 12" , ,_,. IMPORTANT: Do not use nails or screws, This is to pre- vent dulling of the sawbtade in the event you cut into the push block o Position the handle at the center of the plywood base as shown Fasten them together with glue and wood screws Glue Onty_ IMPORTANT:
Make sure the screw heads do not stick out from the bottom of the base, they must be flush or recessed,, The bottom must be flat and smooth enough to slide along the auxiliary fence you are now ready to make Plywood Handle Finished Push Screw Head Must Be Flush Or Recessed 3/8" Plywood Base Cutting Out the Base Auxiliary Fence Making the base: ° Start with a piece of 3/8 inch plywood at least 5-1/2 inches wide or wider and 30 inches long or longer, 30" o Cut the piece to shape and size shown: Making the side:
3E|-l!2r_L 3/8" Thick Plywood Base s /2 ° Start with a piece of 3/4 inch plywood at least 2-3/8 inches wide or wider and 27 inches long or longer Cutting Out the Side Cut the piece to shape and size shown: Putting it together: o Put the pieces together, as shown: IMPORTANT: Make sure the screw heads do not stick out from the bottom of the base, they must be flush or recessed, The bottom must be flat and smooth enough to rest on the saw table without rocking _'= Plywood 27" _"_2_8 3/4" Thick Side " Finished Auxiliary Fence j_.1._.__._..___..." Plywood L This Face and This Edge Must Be Parallel 27