i ,,11,,,,i , ,i,,, i ,i.,,,,i Adjustments (continued) Blade Tilt, or Squareness of Blade to Table When the bevel pointer is pointing directly te the "0" mark on the bevel scale, the sawblade should make a square cut 90° to the table I WARNING: To avoid injury from accidental start, ] turn switch "OFF" and remove plug from power 1 source outlet. To check for squareness, 90 ° position.
1 Raise blade all the way up, raise blade guard 2 Tilt blade a few degrees to the {elt Now tilt blade back te the right as far as it will ge 3 Place the square against the blade Make sure square is net touching the tip of one of the saw teeth 4 If blade is square to table; check peinter A If pointer does net point to "0" mark en the bevel scale, bend peinter to read "0" Pointer Adjusting Screw POINTER AT / ""O" POSITION_J 40