Adjustments (continued) Blade Elevation When the eIevation handwheel is turned clockwise, until it stops, the blade must not be more that 2-5/8 inches above the table If the b}ade extends more than 2-5/8 inches, the motor could interfere with the underside of the table causing misalignment, Step Elevation With the blade extending 2-5/8 inches above the table, the stop collar and spacer must be against the elevation screw pivot nut If the blade extends more that 2-5/8 inches, loosen two screws in stop collar, and readjust it, Spacer !
I "Elevation Screw Pivot Nut 1 f Tilt Screw Tilt Screw Pivot Nut Tilt and Elevation Mechanism The handwheels should turn freely without binding, The turning action can be adjusted by tighten{ng or loosening the screws in the bearing retainer Both handwheels must be removed to reach the adjusting screws Tilt Handwheel Elevation NOTE: When adjusting the screws on the tilt bearing retainer, ho_d the nut inside using a 3/8" wrench, The screws for the elevation bearing retainer can be reached with a small screwdriver through the curved slot on the front of the saw _'_ _-_ Handwheel Adjust Thes_ ! ,_'_-,,_J_ Two Screws _ _OJ F[_ Adjust These Two Screws 42