THIS SNOW THROWER IS EQUIPPED WITH "TRAC-PLUS" AND ONLY MOVES EFFECTIVELY WHEN ENGINE IS RUNNING If your snow thrower must be moved without the aid o! the engine, it will be easier to pull the snow thrower bank- ward by the handles, rather than pushing° On start up, the track drive system may be tight and will loosen up as the snow thrower is used.. After first use, check the track for tension and adjust if necessary, See the Track Adjustment paragraph in the Service and Adjust- " ment_ section of this manual.. Check track adjustment and fasteners regularly.
CONTENTS OF SHIPPING CARTON TOOLS REQUIRED FOR ASSEMBLY 1 - Snow thrower completely assembled except for tlfe_crank assembly, shifter lever knob, the upper h_ndte, and the chute deflector assembly. 1 - P_rts Bag Containing: t - C)wner's Manual (Not Shown) 1 - Etectdc Starter Corc195 Fto (Not Shown) 1 - Knife (to cut carton and plastic ties) 2 - 1/2 inch Wrenches (or adjustable wrenches) 2- 9/16 inch Wrenches (or adjustable wrenches) 2 - 3/4 inch Wrenches (or adjustable wrenches) t - Pair Pliers or Screwdriver (to spread cotter pin) I i,=l==,=,rlr=,,= = == = H CONTENTS OF PARTS BAG =l i=l== ,H,INH imlr=m,riH, G .,H== i 1 - 3/8 Inch Flatwasher 1 - 3/8 Inch Lockwasher 1 - 3/8 Inch Hex Nut !
l l,l,lal l lJl l,l!i 1) 2 - Spare Shear Bolts (5/16 - I8 x 2 Inch Hex Head Bolts) 2 - 5/16-t8 Locknuts ) .I 1 - 318- 16 x 2 Inch Hex Head Bolt "1 2 ° Cable Ties 1 -Plastic Knob HI=IIIll =l,=ll===,, ,,i,,i,l=lll ii 6