ii, i ill ii,lll , illlll,lll iiilll i ill ............................................... ASS LY iHi ii CONTROL PANEL illll,i i i,,i Figure I shows the snow thrower in the shipping position Figure 2 shows the snow thrower completely assembled LOWER HANDLE Reference to the right and left hand side of the snow thrower is from the operator's position at the handte_ CRANK ASSEMBLY TO REMOVE SNOW THROWER CLUTCH CABLE FROM CARTON (See Fig 1) e Cut all four corners q_ the carton fr0om top to bottom and lay the panels flat.. UPPER HANDLE ASSEMBLY Cut the cable ties attached to the augers..
e Cut and discard the ties that secure the crank assembly and place the assembly aside Remove the packing materialfromthe controlpaneL = Cut and discard the packing securing the clutch cables to the lower handle1 ® With two 9/16 inch wrenches, loosen (do not re- move) both bolts securing the upper and lower handles Swing the upper handle into the operating position. NOTE: if the cables have become disconnected from the clutch levers, reinstall the cables as shown in Figure 3. e Tighten both bolts securely. e Roll the snow thrower of{ the skid by pulling on the handle. NOTE: This snow thrower is equipped with a track drive and can be hard to push when the engine is not running.
it is easier to pull the snow thrower backward if it must be moved without the engine running The drive system may be tight when you first use your snow thrower. It loosens up as you use it. HOW TO SET UP YOUR SNOW THROWER TO SET THE SKID HEIGHT For shipping, the height adjust skids are reversed To use your snow thrower, you need to remove the height adjust skids and reinstall as shown in Fig. 2 Then adjust the height adjust skids for surface conditions as follows: TRACTION DRIVE LEVER Loosen the mounting nuts on the skids (See Fig. 2). Q "Z" FITTING O Place the extra shear bolts (in the parts bag) under each end of the scraper bar near but not under the skids.
Push each skid up or down until it touches the ground and the scraper bar is resting on each shear bolt. Be sure the skids are set at the same height on both sides Tighten the mounting nuts