TRACTOR IMPORTANT: To ensure proper assembly, center hole isn blade must align with star on mandrel assembly. Reassemble hex bolt, lock washer and flat washer in exact order as shown. Always observe safety rules when per- forming any maintenance. BRAKE OPERATION If tractor requires more than six (6) feet stopping distance at high speed in highest gear, then brake must be adjusted. (See "TO ADJUST BRAKE" in the Service and Tighten bolt securely (27-35 Ft. Lbs. torque). Up MandrelAssembly Blade Center Hole Adjustments section of this manual). TIRES Maintain proper air pressure in all tires (See =PRODUCT SPECIFICATIONS" on page 3 of this manual).
Keep tiros free of gasoline, oil, or insect control chemicals which can harm rub- ber. / _----Hex Bolt(Grade 8)" *A Grade8 heat treatedbolt can be identifiedby six lineson the bolt head. Avoid stumps, stones, deep ruts, sharp objects and other hazards that may cause tire damage. IMPORTANT: Blade bolt is Grade 8 heat treated. TO SHARPEN BLADE NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion. NOTE: We do not recommend sharpening blade, but if you do, be sure the blade is balanced. Care should be taken to keep the blade balanced.
An unbalanced blade will cause excessive vibration and eventual damage to mower and engine. The blade can be sharpened with a file or on a grinding wheel. Do not attempt to sharpen while it is on the mower. To check blade balance, you will need a 5/8" diameter steel bolt, pin, or a cone balancer. (When using a cone balancer, follow the instructions supplied with bat- ancer). Slide blade onto an unthreaded portion of the steel bolt or pin and hold the bolt or pin parallel with the ground. If blade is balanced, it should remain in a hori- zontal position. If either end of the blade moves downward, sharpen the heavy end until the blade is balanced.
Be sure that operator presence and inter- lock systems are working properly. If your tractor does not function as described below, repair the problem immediately. The engine should not start unless the clutch/brake pedal is fully depressed and attachment clutch control is in the disengaged position. When the engine is running, any attempt by the operator to leave the seat without first setting the parking brake should shut off the engine. When the engine is running and the attachment clutch is engaged, any attempt by the operator to leave the seat should shut off the engine. The-attachment clutch should never OPERATOR PRESENCE SYSTEM NOTE: Do not use a nail for balancing blade.
The lobes of the center hole may appear to be centered, but are not. Center Hole / / J, operate unless the operator is in the seat. BLADE CARE For best results mower blades must be kept sharp. Replace bent or damaged blades. BLADE REMOVAL Raise mower to highest position to allow access to blades. Remove hex bolt, lock washer and flat washer securing blade. InstaJbnew or resharpened blade with trailing edge up towards deck as shown. BATTERY Your tractor has a battery charging system which is sufficient for normal use. However, periodic charging of the battery with an automotive charger will extend its life. 19