Keep batteryand terminals clean. Keep battery bolts tight. Keep small vent holes open. Recharge at 6-10 amperes for I hour. Check the crankcase oil level before start- ing the engine and after each eight (8) hours of operation. "Tighten oil fill cap/dip- stick securely each time you check the oil level. TO CLEAN BATTERY AND TERMINALS TO CHANGE ENGINE OIL Corrosion and dirt on the battery and ter- minals can cause the battery to "leak = power. Remove terminal guard. . Disconnect BLACK battery cable first then RED battery cable and remove battery from tractor. Rinse the battery with plain water and dry. Clean terminals and battery cable ends with wire brush until bright.
Coat terminals with grease or petroleum jelly. Reinstall battery (See "REPLACING BATTERY" in the SERVICE AND ADJUSTMENTS section of this manu- al). V-BELTS Check V-belts for deterioration and wear Determine temperature range expected before oil change. All oil must meet API service classification SF, SG or SH. Be sure tractor is on level surface. Oil will drain more freely when warm. Catch oil in a suitable Container. Remove oil fill cap/dipstick. Be careful not to allow dirt to enter the engine when changing oil. Remove drain plug. After oil has drained completely, replace oil drain plug and tighten securely. Refill engine with oil through oil fill dip- stick tube. Pour slowly.
Do not overfill. For approximate capacity see "PROD- UCT SPECIFICATIONS" on page 3 of this manual. after 100 hours of operation and replace if necessary. The belts are not adjustable. Replace belts if they begin to slip from wear. Use gauge on oil fill cap/dipstick for checking level. Be sure dipstick cap is tightened securely for accurate reading. Keep oil at "FULL" line on dipstick. AIR FILTER TRANSAXLE COOLING Your engine will not run properly using a dirty air filter. Clean the foam pre-cleaner after every 25 hours of operation or every season.
Service paper cartridge every 100 hours of operation or every season, Keep transaxle free from build-up of dirt and chaff which can restrict cooling. ENGINE Only use high quality detergent oil rated with API service classification SF, SG or SH. Select the oil's SAE viscosity grade according to your expected operating |em- perature. LUBRICATION Air Screen Oil Drain_ jj._ Plug Oil FillCap/DipsEck / _j1--_ '-"T- whichever occurs first. SAE VISCOSIIY GRADES Service air cleaner more often under dusty conditions. -2O" TEMPERATURE RANGE PJ_FICIPATED BEFORE N_XT OIL CHANGE Remove knob(s) and cover. TO SERVICE PRE-CLEANER NOTE:
Although multi-viscosity oils (5W30, 10W30 etc.) improve starting in cold weather, these multi-viscosity oils will result in increased oil consumption when used above 32°F. Check your engine oil level more frequently to avoid possible engine damage from running low on oil. Change the oil after every 25 hours of operation or at least once a year if the tractoLLs.not used for 25 hours in one year. Slide foam pre-cleaner off cartridge. Wash it in liquid detergent and water. Squeeze it dry in a clean cloth. Saturate it in engine oil. Wrap it in clean, absorbent cloth and squeeze to remove excess oil. If very dirty or damaged, replace pre- cleaner. Reinstall pre-cleaner over cartridge.
Reinstall cover and secure with knob(s). 2O