Seres RAFTSM N — Seres RAFTSM N Электрический Моторный Косилка 19.5 Л.С. Руководство по эксплуатации и обслуживанию

TO LEVEL MOWER HOUSING equal in length. Both links should be approximately 10-3/8". If links are not equal in length, adjust one link to same length as other link. To lower front of mower loosen nut "E" Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly inflated (See "PROD- UCT SPECIFICATIONS" on page 5 of this manual). If tires are over or underinflat- ed, you will not propedy adjust your mower. on both front links an equal number of tums. When distance "D" is 1/8" to 1/2" lower SIDE-TO-SIDE ADJUSTMENT at front than rear, tighten nuts "P against trunnion on both front links.

To raise front of mower, loosen nut "P from trunnion on beth front links. -. Raise mower to its highest position. At the midpoint of beth sides of mower, measure height from bettom edge of mower to ground. Distance "A" on both sides of mower should be the same or within 1/4" of each other. Tighten nut "E" on both front links an equal number of tums. When distance "D" is 1/8" to 1/2" lower at front than rear, tighten nut "P against trunnion on both front links. Recheck side-to-side adjustment. If adjustment is necessary, make adjust- ment on one side of mower only. To raise one side of mower, tighten lift link adjustment nut on that side.

To lower one side of mower, loosen lift link adjustment nut on that side. NOTE: Each full tum of adjustment nut will change mower height about 1/8". Recheck measurements after adjusting. Mandrel Bottom _ Bottom o, Both Front Links Should be Equal in Length (_ Suspension DO Nut "P. Nut "E" FRONT-TO-BACK ADJUSTMENT IMPORTANT: Deck must be level side-to- side. If-t_ following front-to-back adjust- ment is necessary, be sure to adjust both front links equally so mower will stay level side-to-side.

To obtain the best cutting results, the mower housing should be adjusted so that the front is approximately 1/8" to 1/2" lower than the rear when the mower is in Front Links TO REPLACE MOWER BLADE DRIVE BELT (See Illustration Next Page) The mower blade drive belt may be replaced without tools. Park the tractor on level surface. Engage parking brake. BELT REMOVAL - Remove mower from tractor (See "TO REMOVE MOWER" in this section of its highest position• Check adjustment on right side of tractor. Measure distance "D" directly in front and behind the mandrel at bottom edge of mower housing as shown. Befm'_making any necessary adjust- ments, check that both front links are this manual).

Work belt off both mandrel pulleys and idler pulleys. Pull belt away from mower. 23