SE AND A TO REPLACE HEADLIGHT BULB TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 28) ° Raise hood. Raise hood_ ° Pull bulb holder out of the hole in the backside of the grill. Replace bulb in holder and push bulb hoIder securefy back into the hole in the backside of the gritt, . Close hood. Unsnap headlight wire connector. Stand infront of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor. To replace, reverse above procedures° INTERLOCKS AND RELAYS Loose or damaged wiring may cause your tractor to run poorly, stop running, or' prevent it from starting. ° Check wiring. See electrical wiring diagram in the Repair Parts section of this manual.
HOOD TO REPLACE FUSE Replace with 30 amp automotive-type plug-in fuse. The fuse holder' is located behind the dash. HEADLIGHT WIRE CONNECTOR FIG. 28 22