AS LY INSTALL THE SHIFTER LEVER TO ® Stand the snow thrower up on the front of the auger housing, as shown in Figure 6. o Cut the plastic tie which holds the shifter lever as- sembly to the shift bracket° Remove the Iocknut, washer, spring and the bolt.. Reposition the shifter lever into the slot in the control panel, as shown in Figure 6 and reinstall the bolt, spring washer and the Iocknut. ® Tighten the Iocknut until 1/8" to 3/16" (2or 3threads) of the bolt protrude past the Iocknuto Thread the shifter lever knob onto the threaded end of the shifter lever until it is tight. Move the shifter lever through all the speeds to en- sure proper tension of the spring.
If the shifter Iever sticks in any of the notches, loosen the Iocknu[ 1/4 turn at a time until the shifter lever moves freely.. TO CHECK/ADJUST CLUTCH CONTROL CABLES The control cables attached to the auger clutch lever and traction clutch lever may need to be adjusted before you use your snow thrower. For instructions on checking or adjusting the clutch control cables, see To Adjust The Clutch Control Cables paragraph on page 18. FIG. 6 9