СИ20 — 5.1 Wiring recommendations

Figure 4.8 – The device in Щ2 housing mounted in the control panel thickness of 3 mm 5 Electrical connection 5.1 Wiring recommendations To ensure the reliability of electrical connections it is recommended to use copper stranded cables, the ends of which should be carefully cleaned and tinned. Otherwise use cable lugs before connection. Cable conductors should be stripped so that their bare ends do not protrude beyond the terminal strip after connecting to the device. The cable cross section must be not more than 1 mm 2 . General requirements for connection lines:

During the cabling, communication lines that connect the Device with sensors must be isolated to a separate circuit (or several circuits) and placed separately from power cables or other sources of high-frequency and impulse interferences; 18