To protect the Device inputs from the effects of industrial electromagnetic interference, the communication lines between Device and sensors should be shielded. Special cables with shielding or grounded steel pipes of suitable diameter can be used. The cable shielding should be connected to the functional ground terminal (FE) in the control panel; Network interference filters should be installed in the power supply lines; Spark-fighting filters should be installed in the switching lines of power equipment. When installing the system in which the Device operates, you should follow the rules for effective grounding:
all grounding lines must be laid in Y-connected circuit, ensuring good contact with the grounding element; all earthing circuits must be made with wires of the largest possible cross-section; it is forbidden to connect the device terminal "Common" with grounding lines. 5.2 Getting Started DANGER After unpacking the device, make sure that it has not been damaged during transportation. If the Device was kept for a long time at a temperature below minus 20 °С, then before turning it on and starting work, it should be kept in a room with a temperature corresponding to the operating range for 30 minutes. To connect Device: 1. Connect the Device to a power source. 19