СИ20 — 6.3 Switch on and operation

Table 6.3 (continued) 6.3 Switch on and operation During operation (see Figure 6.4 ), the Device counts the number of pulses arriving at its counting input (input 1), converts this quantity into a physical value, and displays the value on the indicator. The counter of the Device operates in the mode of direct counting (counting of pulses from zero upward). If the maximum counting value (999999) is exceeded, the number of counted pulses is reset and the counter continues counting. The logic of the counter on the start/stop signal (input 2) is as follows: the first impulse (starting) comes to this input and enables the counting; when the next (stop) pulse arrives, the counting stops.

If there is an active Reset signal (input 3), the number of counted pulses is reset. 31 Button Operating mode Function Operation Select editable digit when changing parameter value (used with buttons and ) Setup Operation View and change the setpoint value (if the setpoint value is not locked) Setup Enter and exit the settings group Enter and exit the parameter editing mode Save the new parameter value in non-volatile memory of the device