Chapter 3: Installation CAUTION: Do not remove the SD card when power is connected to the controller. Removing an SD Card To remove an SD card from a SmartController EX motion controller: 1. Make sure that the controller is disconnected from its power source. 2. Locate the SD compartment (see the following figure). SD Card Slot Figure 3-5. SD Memory Card Compartment NOTE: If you are replacing an existing SD, the original must be sent to the factory for replacement. 3. Press the SD card in, and release. The card will pop out. Remove the card. Contact your sales representative for instructions on returning it.
Installing an SD Card To install an SD card into a SmartController EX motion controller: 1. Make sure that the controller is powered off. 2. Locate the SD card compartment (see the preceding figure). 3. Carefully remove the SD card from the READ ME FIRST box or shipping container. Position the card so its contacts are facing towards the controller and to the left. The label will be facing to the right. 4. Insert the SD card into the controller. Once installed, we recommend that you do not repeatedly remove and insert the SD card. SmartController EX User’s Guide, 11069-000 Rev. F Page 18 of 92