Contents Connections Playback Settings Tips Appendix o DTS Neural:X o IMAX Audio Settings DTS Neural:X Expands the non-object based audio signals and optimizes them for your speaker configuration. You can configure special IMAX audio settings to recreate the conditions of an IMAX theater. On (Default) : Use “DTS Neural:X”. Auto (Default) : Applies the optimized speaker settings to reproduce similar to the IMAX theater environment. Off: Do not use “DTS Neural:X”. Manually adjusts the “High Pass Filter”, “Low Pass Filter” and “Subwoofer Output”. Manual: 0 You can set this when sound mode is “DTS:X”. o IMAX Sets the audio mode for IMAX playback.
0 You can set this when sound mode is “IMAX DTS” or “IMAX DTS:X”. 0 “Speakers” - “Crossovers”, “Bass” - “Subwoofer Output” and “LPF for LFE” in the menu cannot be applied during IMAX playback. Auto (Default) : Automatically enables IMAX mode when IMAX content is detected. Off: Disables IMAX mode. o High Pass Filter Set the high pass filter cutoff frequency for all speakers during IMAX playback. 0 This setting cannot be set when headphones are used. 40 Hz / 60 Hz / 80 Hz / 90 Hz / 100 Hz / 110 Hz / 120 Hz / 150 Hz / 180 Hz / 200 Hz / 250 Hz (Default: 80 Hz) 0 You can set this when “IMAX Audio Settings” is set to “Manual”. Front panel Display Rear panel 173 Remote Index