Downloaded from https://www.everyspec.com MIL+DBK-663(AT ) 2.2.27 tendency of ~. A general concept for the typical valuea or central a distribution. 2.2.28 lkn. The aver- of values in a group of me~nts . hiiaa- W middle =lue in a group of mamwemmta, when arranged froq lowest to Mgheat . If the *r of values ieteven, by convention the average of the middle * value8 is used ae the median. Subgroup medians fom the basis for a simple control chart for process lmtion. W- ~ dOSi~tOd by G tilda (~) msr the symbol for h 2.2.29 individual value, e.g., X is the median of a ~. 2.2.30 ~.
The operational ~ilosophy that makes best use of the talents within the company to produce products of increasing quality for our custunera In an increasingly efficient way that protects the return on investment to the stockholders. This is a dynamic strategy designed to enhance the strength of the company in the face of present and future market conditions. It contrasts with any static strategy that accepts (explicitly or implicitly) some particular level of outgoing defects as inevitable. 2-2-31 ~.
Units which do not confom to a specification or other inspection standard; cometimes called discrepant or defective units- To analyze systems producing nonconforming units, p and np contro~ charts are used. 2.2.32 S~ific occurrences of a condition which does not conform to s~cificatio& or other inspection standards; sometimes called discrepancies or defects. An individual nonconforming unit can have the potential for more than one mnconfonnity (e.g., a door could have several dents and dings; a functional check of a carburetor could reveal any of a number of potential discrepancies). To analyze systems producing nonconformities, c and u control charts are used.
2.2.33 A continuous, symmetrical, bell-shapd frequency distribution for variables data that underlies the control charts for variables. When measurements have a normal distribution, about 68.26% of all individuals lie within plus or minus one standard deviation unit of the mean, about 95.44% lie within plus and minus two standard deviation units of the mean, and about 99.73% lie within plus and minus three stan- deviation units of the mean.
These percentages are the basis for control limits ~d control chart analysis (since subgroup averages tend to be normally distributed even if the output as a whole is not), and for many capability decisions (since the outpt of many industrial processes follows the nomal distribution). 6