MIL MIL-HDBK-683(AT) — MIL-HDBK-683(AT) Statistical Process Control (SPC) Handbook - Implementation & Evaluation PDF

Downloaded from https://www.everyspec.com MIIADBK-683(AT) 2.2.16 ~. A way of describing the output of a comon—cause system of variation, in which individual values are not predictable, bt the outcomes as a group form a pattern that can be described in terms of its location, spread, and shape. kcatiOn i8 cXnmmily mlpmssed by the mean or average, or by the median. spread is Sacpreasedin terms of the standard dsviation or tk range of a sample. Shape lxJvolve8many characteristics, such as, Synmnetry and gaekdneas , tnlt these are often summarized by using the nameofacounon diatrilmtion, such as, the nomal, binmdnal, or Foiawn.

2.2.17 Is an analyt%cd technique which uaea the po~ntid failure modes of ~ procesa and the resulting effecta to prioritize corrective actions, and for identifying the characteriutics of a proce’sathat - vital p) product guality. 2-2-18 @uummcY- The diffemme betueen the observed average of measurements and the true average of the same parts using precision instrmenta. 2.2.19 . The difference in the accuracy values through the expected operating range of the gage- 2.2.20 . The variation in m~ nt8 obtained with one gage when uq~ several times by one operator while measuring the identical characteristic on the same part.

Z-2*21 ~- The variation in the average of the measurements made by different operators using the same gage while measuring the identical characteristic on the same part. 2-2-= Gag~taM&&. The difference in the average of no less than two 8et8 of meaeurementa obtained with a gage on the same parte as a result of time. 2.2.23 ~gm. The combination of gage accuracy, re~atability, reproducibility, stability and linearity. 2.2.24 ~ A pictorial way to display data in frequency form. This provides a viui way to evaluate the form of the data. 2.2.25 XndixM@. A single unit or a single measurement Of a characteristic. 2.2.26 Thh step ha8 been called the “’MissingLink” in SPC.

It is a techniq& for evaluating and quantifying the errors present in inspection syatms for either variables or attributes data- It also defines the criteria of when to accept end when to reject any given inspection and test proceaa. Inspection and test capability studies also set the stage for the next step of the SPC process. 5