Downloaded from https://www.everyspec.com - CHAPTKR3 AWANTAGESAND mALs OF WC MIL-HDBK-683(AT) a. . SPC ia the application of statistical techniques to management of an operation or process. It i.uvolvea the identification of events that are beyond the natural variation of the process and the systematic eltit ion of the causes of such events. When appropriate statistical techniques are hilt into the procee8 or operation, mana@ment -ins the ability to understand the nature of the process variation and to bring the variation within the desired limits. There is a natural variation inherent in any mess.
The diameter of a drilled hole, for example, will vary due to wear of the drill bit, material hardness, operator skill and accuracy, and ambient temperature. For another example, time to receive your food in a restaurant will vary according to the efficiency of the serving person, the reliability of the cook, the availability of ingredienta, and the workload on the restaurant personne1. b. ~t~z% V~ . Variation will exist within the process. Parts will be acceptable only ken they conform to the specification.
However, to control a process, reduce variation, and ensure that the output continues to meet the expressed requirements, the causes of variation must be identified in the data or in dispersion (spread) of the data. Collection of these data are characterized as mathematical models called “distributions” that are used to predict the overall performance. Certain factors which may cause a variation that cannot be adequately explained by the process distribution are called “’assignablecauses”’. Unless these assignable causes are identified and removed, they will continue to affect the process in an unpredictable manner.
A process is said to be in statistical control when the only source variation is the natural process variation and “assignable causes” have been eliminated. Variation that is outside of the desired process distribution can usually be corrected by someone directly connected with the process. For example, a machine set improperly may produce defective parts. The responsibility for corrective/preventiveaction in this case belongs to the operator, who can readjust the machine to prevent recurring defects. c.~ ~ . v~ . Causes of natural variation may only be correctable by management action such as capital investment in new equipment or a redesign of the material processing.
It may, in fact, be determined that enuugh variation cannot be economically eliminated to produce items consistently within apecificzktion. 14