MIL MIL-HDBK-683(AT) — MIL-HDBK-683(AT) Statistical Process Control (SPC) Handbook - Implementation & Evaluation PDF

Downloaded from https://www.everyspec.com tfILrHIIBK-683(AT) a. Figure 1-3: The control chart in this figure is an example of an average ~ and a range (R) chart for a variable measured on a pueh rod at a stud weld o~rat ion. After 25 subgroups of 5 parts each, process centerline and control limits have ken calculated and are recorded on the chart. ~nta were taken each hour over three shifts. The process average and range is in control. b. Fi 2-3: r The control chart in this figure is an example of an average ) ad range (R)chart for spring compression force. Subgroupe of five springa each have been measured uvary2houre (hr)and &taisrecmded on the chart for 25 subgruupe.

I!rocesscenterlines and control limits are recoded on the chart. I Figure 3-3: The control chart in this figure is an example of a for fraction def~tive found at the final inspection of an ammunition shell. Inspection is performed oaoe eaoh~ on su~ of 25 parta each. The centerline of the process waa oalaulatad at 0.008 and the upper control unit at 0.0615. The spikes on +he ohart ooour becaue of the relatively small subgroup size. only two type8 of defmta are mcomied &t this station.