Downloaded from https://www.everyspec.com MIL-HDBK-683(AT) Anothar aapect of Cause Analysis is that it comparea and createe c-~ative test bases. The advantage of this technique is the high quality of the results generated. Only known facts and relevant information are used to draw out likely causes. When using Cause Analysis it is useful to think of the pmblea as an iceberg - what you see initially hints at the ~tirety of the probla. ~t~ ~lYsis, aqer ean then determine the actual size and ecope of the problem. Bybe@ aware of this “iceberg*’phen~, Wst mana@ra try to better understand the problem at hand by collecting more data. Then they ~ h Ale to see the whole iceberg (specific problem).
Houewer, they still may be unable to deal with the problem unless they classify the data into a useful fomat, separating the relevant fmm the irrelevant. They don-t need to collect &ta on the entire polar cap (whole problem) in order to put a ~icular ioeberg (problem) into proper focus. Cause Analysis will provide the format to help classify data and acts as a guide to co1lect only the relevant data in terms of what, where, when and magnitude. Since this is a very structured technique, it also requires further training for application. 4.5.5 ~ .
The objective of a designed experiment is usually to determine which of the many variables or causes are the met influential on some response or output variable. The desi~ experiment is the only way of properly evaluating end quantifying the interaction between the variablea. To perform a “Designed Experiment”, the follow~ st~ are presented to assure the experiment is properly designed, conducted, analyzed and presented. a. Plan the experiment. b. ~elop the de8ign. c. Conduct the experiment- d. Perform the analysis. e. Report the results. 4.5.6 (- MEA is a method of problem prevention that can be carried out by desi~ and reliability engineering in the early stages of product introduction.
It assigns probability of detection to each failure mode. This technique is a structured method of design review that causes engineers to consider potential failure modes and to rank failure modes according to their impact on reliability. FTIRAwill identify the problems that need immediate attention and will define preventive action that must be taken prior to relea8e of a new design. 23