A+ SERVER 1012G-MTF USER'S MANUAL 5-9 Connector Definitions Power Connectors A 24-pin main power supply connector(JPW1) and three 8-pin CPU PWR connector (JPW2) on the motherboard. These power connectors meet the SSI EPS 12V specification. In addition to the 24-pin ATX power connector, the 12V 8-pin CPU PWR connector at JPW2 must also be connected to your power supply. See the table on the right for pin definitions. Warning : To prevent damage to the power supply or motherboard, please use a power supply that contains both a 24-pin and 8-pin power connectors. Be sure to connect these connectors to the 24-pin (JPW1) and the three 8-pin (JPW2) power connectors on the motherboard.
Failure in doing so will void the manufacturer warranty on your power supply and motherboard. Required Connection PW_ON Connector The PW_ON connector is on pins 1 and 2 of JF1. This header should be connected to the chassis power button. See the table on the right for pin definitions. Reset Connector The reset connector is located on pins 3 and 4 of JF1 and attaches to the reset switch on the computer chassis. See the table on the right for pin definitions. Overheat/Fan Fail LED (OH) Connect an LED to the OH connection on pins 7 and 8 of JF1 to provide advanced warning of chassis overheating or fan failure. Refer to the table on the right for pin definitions and status indicators.
5-14 ATX Power 24-pin Connector Pin Definitions Pin# Definition Pin # Definition 13 +3.3V 1 +3.3V 14 -12V 2 +3.3V 15 COM 3 COM 16 PS ON _ 4 +5V 17 COM 5 COM 18 COM 6 +5V 19 COM 7 COM 20 Res (NC) 8 PWR OK _ 21 +5V 9 5VSB 22 +5V 10 +12V 23 +5V 11 +12V 24 COM 12 +3.3V 12V 8-pin PWR Connector Pin Definitions Pins Definition 1 through 4 Ground 5 through 8 +12V Power Button Pin Definitions (JF1) Pin# Definition 1 PW ON _ 2 Ground Reset Button Pin Definitions (JF1) Pin# Definition 3 Reset 4 Ground OH/Fan Fail LED Pin Definitions (JF1) OH/Fan Fail LED Status State Indication Pin# Definition Solid Overheat 7 Vcc Blinking Fan fail 8 Control