Chapter 5: Advanced Motherboard Setup NIC2 (LAN2) LED The LED connections for LAN2 are on pins 9 and 10 of JF1. Attach LAN LED cables to display network activity. See the table on the right for pin definitions. NIC1 (LAN1) LED The LED connections for LAN1 are on pins 11 and 12 of JF1. Attach LAN LED cables to display network activity. See the table on the right for pin definitions. HDD LED The HDD LED connection is located on pins 13 and 14 of JF1. Attach the hard drive LED cable here to display disk activity (for any hard drives on the system, including SAS, Serial ATA and IDE).
See the table on the right for pin definitions Power On LED The Power On LED connector is located on pins 15 and 16 of JF1. This connection is used to provide LED indication of power being supplied to the system. See the table on the right for pin definitions. NMI Button The non-maskable interrupt button header is located on pins 19 and 20 of JF1. Refer to the table on the right for pin definitions. Video Connector A Video (VGA) connector is located below the COM Port on the IO backplane. This connector is used to provide video and CRT display.
5-15 NIC2 LED Pin Definitions (JF1) Pin# Definition 9 Vcc 10 Activity NIC1 LED Pin Definitions (JF1) Pin# Definition 11 Vcc 12 Activity HDD LED Pin Definitions (JF1) Pin# Definition 13 Vcc 14 HD Active Power LED Pin Definitions (JF1) Pin# Definition 15 5V Stby 16 Control NMI Button Pin Definitions (JF1) Pin# Definition 19 Control 20 Ground