Supermicro A+ Server 1012G-MTF — Supermicro A+ Server 1012G-MTF User's Manual (1U Rackmount Server) PDF

Chapter 5: Advanced Motherboard Setup Compact Flash Card PWR Connector A Compact Flash Card Power Connector is located at JWF1. For the Compact Flash Card to work properly, you will need to enable with JCF1 and connect a Compact Flash Card power cable to JWF1 first. Trusted Platform Module Header The JLPC1 header is used to connect a Trusted Platform Module (TPM), available separately from a third-party vendor. A TPM is a security device that allows encryption and authentication of hard drives, disallowing access if the TPM associated with it is not installed in the system. See the table on the right for pin definitions.

LAN1/2 (Ethernet Ports) Two Gigabit Ethernet ports (designated LAN1 and LAN2) are located beside the VGA port. Additionally, there is a dedicated LAN for IPMI on top of the two rear USB ports. These Ethernet ports accept RJ45 type cables. Note: NC indicates no connection.

5-19 Trusted Platform Module Header Pin Definitions (JLPC1 ) Pin# Definition Pin# Definition 1 LCLK 2 GND 3 LFRAME 4 No Pin 5 LRESET 6 VCC5 7 LAD3 8 LAD2 9 VCC3 10 LAD1 11 LAD0 12 GND 13 RSV0 14 RSV1 15 SB3V 16 SERIRQ 17 GND 18 CLKRUN 19 LPCPD 20 RSV2 LAN Ports (LAN1/2) Pin Definition Pin# Definition Pin# Definition 1 P2V5SB 10 SGND 2 TD0+ 11 Act LED 3 TD0- 12 P3V3SB 4 TD1+ 13 Link 100 LED (Yellow, +3V3SB) 5 TD1- 14 Link 1000 LED (Yellow, +3V3SB) 6 TD2+ 15 Ground 7 TD2- 16 Ground 8 TD3+ 17 Ground 9 TD3- 18 Ground