A+ SERVER 1012G-MTF USER'S MANUAL SATA Drives: Because of their hotswap capability, you do not need to access the inside of the chassis or power down the system to install or replace SATA drives. Proceed to the next step for instructions. Note: The operating system you use must have RAID support to enable the hot-swap capability of the drives. Accessing the Drive Bays DVD-ROM Drive: For installing/removing a DVD-ROM drive, you will need to gain access to the inside of the server by removing the top cover of the chassis. Proceed to the "DVD-ROM Drive Installation" section in this chapter for instructions. Note that only a "slim" DVD-ROM drive will fit into the 1012G-MTF.
Use caution when working around the SATA backplane. Do not touch the backplane with any metal objects and make sure no ribbon cables touch the backplane. Also, regardless of how many drives are installed, all four drive carriers must remain in the chassis to maintain proper airflow. SATA Drive Installation Mounting a Drive in a Drive Carrier The SATA drives are mounted in drive carriers to simplify their installation and removal from the chassis. These carriers also help promote proper airflow for the system. For this reason, even empty carriers without drives installed must remain in the chassis. 1. Install a new drive into the carrier with the printed circuit board side facing 2.
Secure the drive to the carrier with six screws, as shown in Figure 6-4. down so that the mounting holes align with those in the carrier. Figure 6-4. Mounting a Drive in a Carrier 6-2