Chapter 6: Advanced Chassis Setup Installing/Removing SAS/SATA Drives 1. To remove a carrier, push the release button located beside the drive LEDs. 2. Swing the colored handle fully out and use it to pull the unit straight out (see Note: There is no onboard RAID support for SAS/SATA drives. Figure 6-5). Figure 6-5. Removing a Drive from the Server Note ! Enterprise level hard disk drives are recommended for use in Supermicro chassis and servers. For information on recommended HDDs, visit the Supermicro Web site at http://www.supermicro.com/products/nfo/files/storage/SAS-CompList. pdf SATA Backplane The SATA drives plug into a backplane that provides power, drive ID and bus termination.
A RAID controller can be used with the backplane to provide data security for the drives. The backplane is already preconfigured, so there are no jumpers or switches present on it. 6-1