Chapter 4: System Safety NMI Button The non-maskable interrupt button header is located on pins 19 and 20 of JF1. Refer to the table on the right for pin definitions. Universal Serial Bus Ports Two Universal Serial Bus ports (USB 2.0) are on the serverboard. See the table on the right for pin definitions. USB Headers Two USB 2.0 headers (USB2/3) are also included on the motherboard. These may be connected to provide front side access. A USB cable (not included) is needed for the connection. See the table on the right for pin definitions. Note: NC indicates no connection. Fan Headers This motherboard has eight fan headers (Fan1 to Fan8).
These 4-pin fans headers are backward compatible with 3-pin fans. However, fan speed control is available for 4-pin fans only. The fan speeds are con trolled by the BIOS. See the table on the right for pin definitions Video Connector A Video (VGA) connector is located below the COM Port on the IO backplane. This connector is used to provide video and CRT display.
5-13 NMI Button Pin Definitions (JF1) Pin# Definition 19 Control 20 Ground Universal Serial Bus Ports Pin Definitions (USB0/1) USB0 Pin # Definition USB1 Pin # Definition 1 +5V 1 +5V 2 PO- 2 PO- 3 PO+ 3 PO+ 4 Ground 4 Ground Universal Serial Bus Headers Pin Definitions (USB2/3) USB2 Pin # Definition USB3 Pin # Definition 1 +5V 1 +5V 2 PO- 2 PO- 3 PO+ 3 PO+ 4 Ground 4 Ground 5 Key 5 NC Fan Header Pin Definitions Pin# Definition 1 Ground 2 +12V 3 Tachometer 4 PWR Modulation