Chapter 2: Installation Overheat LED T able 2-8 O verheat LED Pin Definitions (JF1) Pins 7 and 8 of JF1 are for the Overheat LED, which provides you with advanced warning of chas- sis overheating. This LED will also illuminate if the blower fan fails, which will cause the chassis tem- perature to rise. Refer to Table 2- 8 for pin definitions and Figure 2-2 for pin locations. Reset T able 2-9 Reset Button Pin Definitions (JF1) The Reset connection is located on pins 3 and 4 of JF1. This con- nector attaches to the Reset but- ton on the control panel, which al- lows you to reboot the system. See Table 2-9 for pin definitions and Figure 2-2 for pin locations.
PWR_ON T able 2-10 PW R Button Pin Definitions (JF1) The PWR_ON connection is lo- cated on pins 1 and 2 of JF1. This connector attaches to the Power button on the control panel, which allows you to turn the power to the system on and off. The user can also configure this button to function as a suspend button. (See the Power Button Mode set- ting in BIOS.) To turn off the power when set to suspend mode, hold down the power button for at least 4 seconds. See Table 2-10 for pin definitions and Figure 2-1 for pin locations. 2-11 Pin Number Definition 7 8 + - Pin Number Definition 3 4 Reset Ground Pin Number Definition 1 2 PW _ON Ground