Chapter 2: Installation 2-9 Jumper Settings Explanation of Jumpers 3 2 1 Connector Pins To modify the operation of the motherboard, jumpers can be used to choose between optional set- tings. Jumpers create shorts be- tween two pins to change the function of the connector. Pin 1 is identified with a square solder pad on the printed circuit board. See the motherboard layout pages for jumper locations. Jumper Cap 3 2 1 Setting Pin 1-2 short Note: Closed refers to the jumper being set over both pins on a two-pin jumper header. Open refers to the jumper being set over a single pin of a two-pin jumper.
Front Side Bus Speed T able 2-19 Front Side Bus Speed Jum per Settings (JP2) JP2 sets the FSB speed. CPU speed = FSB x Core/Bus ratio. Core/Bus Ratio settings are de- scribed in Section 2-9. See Table 2-19 for jumper settings. * Note: The Auto setting allows the CPU to set the speed. PCI 64 Speed Setting T able 2-20 PCI 64 Speed Setting Jum per Settings (JP13) JP13 sets the speed PCI 64. When JP13 is set to "open", the PCI speed is set 66MHz, and when the JP13 is closed, the PCI speed is set to 33 MHz. See Table 2-20 for jumper settings. 2-15 Jumper Position Definition 1-2 2-3 Open Auto 100 MHz 133 MHz Jumper Position Definition Open Closed 66 MHz 33 MHz