Supermicro P3TDLR — Supermicro P3TDLR Motherboard User's Manual PDF (Revision 1.0a)

S UPER P3TDLR User's Manual Wake-On-Modem T able 2-16 W ake-on-m odem Pin Definitions (W O M) The Wake-on-Modem (WOM) header allows your computer to receive and be "awakened" by an incoming call when in the suspend state. Refer to Table 2-16 for pin definitions. You must also have a WOM card and cable to use WOM. Wake-On-LAN T able 2-17 W ake-O n-LAN Pin Definitions (W O L) The Wake-On-LAN (WOL) header allows the system to be woken up upon receiving an appropriate sig- nal via the LAN. You must enable the LAN Wake-Up setting in BIOS to use this feature and have a LAN card with a Wake-on-LAN connector and cable. Refer to Table 2-17 for pin definitions.

2-8 DIP Switch Settings T able 2-18 CPU Core/Bus Ratio Selection (DIP Sw itch 1) DIP Switch 1: Core/Bus Ratio One DIP switch labeled SW1 is lo- cated on the P3TDLR motherboard. The switch housing has four indi- vidual switches. They are used to set the CPU core/bus ratio. The table on the right will show you how to choose the proper CPU core/bus ratio. After determining the ratio, refer to Table 2-18 for the correct settings of DIP switch 1. Core/bus ratio = CPU speed / front side bus speed. Example: a 550 MHz CPU running at a 100 MHz FSB speed:

550 (MHz) / 100 (MHz) = 5.5 (ratio) 2-14 Pin Number Definition 1 2 Ground W ake-up Pin Number Definition 1 2 3 +5V Standby Ground W ake-up 133/100 CPU SW 1 #1 SW 1 #2 SW 1 #3 SW 1 #4 600/450 667/500 733/550 800/600 866/650 933/700 1G/750 1.06G/800 1.13G/850 1.20G/900 1.26G/950 1.4G/1G ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON