Chapter 2: Installation ATX PS/2 Keyboard and PS/2 Mouse Ports T able 2-13 PS/2 Keyboard and Mouse Port Pin Definitions (J28) The ATX PS/2 keyboard and the PS/2 mouse are located on J28. See Table 2-13 for pin definitions. (The mouse port is above the key- board port. See Figure 2-12.) Universal Serial Bus (USB) T able 2-14 Universal Serial Bus Pin Definitions Two Universal Serial Bus connec- tors are located on U38. USB1 is the bottom connector and USB2 is the top connector. Refer to Table 2-14 for pin definitions. USB1 USB2 Extra USB Connectors (J105/J106) J105 is USB3, and J106 is USB4. You will need a USB cable (not in- cluded) to use this connection.
Re- fer to Table 2-14 for pin definitions. LAN1/LAN2 Ports Two Ethernet ports (designated NIC1 and NIC2) are located beside the VGA port on the I/O backplane. These ports accept RJ45 type cables. There are two jumpers for the LAN1/LAN2 ports: JP8: NIC 1 Enable/Disable(Open: enable), JP24: NIC2 Enable/Disable (Open: enable). Each indicate a success- ful connection (yellow) and activ- ity (green).
RJ45 Ethernet Port SLED1 (SCSI LED) Indicator T able 2-15 SLED1 (SCSI LED) Pin Definitions 2-13 Pin Number 1 Definition Data 2 3 4 5 6 NC Ground VCC Clock NC Pin Number Definition Pin Number Definition 1 +5V 2 P0- 3 P0+ 4 Ground 5 N/A 1 +5V 2 P0- 3 P0+ 4 Ground 5 Key The SLED connector is used to pro- vide an LED indication of SCSI ac- tivity. Refer to Table 2-15 for con- necting the SCSI LED. Pin Number Definition 1 2 3 4 + - - +