Chapter 2: Installation VGA Enable/Disable VG A Enable/Disable Jum per Settings (JP1) JP1 allows you to enable or dis- able the VGA port. The default position is on pins 1 and 2 to en- able VGA. See the table on the right for jumper settings. Watch Dog Enable/Disable W atch Dog Enable/ Disable Jum per Settings (JP2) JP2 is used to enable or disable the Watch Dog function. This jumper is used together with the Watch Dog enable function in BIOS. Enable both the jumper and the BIOS setting to use the Watch Dog feature. See the table on the right for pin definitions.
Fan Status Select Fan Status Select Jum per Settings (JP4) JP4 allows you to change the sta- tus of the Overheat/Chassis fan to either activate only during an over- heat condition or to remain active at all times (as a chassis fan). The default position is open. See the table on the right for jumper set- tings. Jumper Position Open Closed Definition Overheat Always On LAN1 Enable/Disable Jum per Settings (JPL1) LAN1 Enable/Disable Change the setting of jumper JPL1 to enable or disable the LAN1 port on the motherboard. See the table on the right for jumper settings. The default setting is Enabled. Note:
Gb port on the P4DE8/P4DEI, Mb port on the P4DEE 2-15 Jumper Position Definition 1-2 2-3 Enabled Disabled Jumper Position Definition Open Closed Disabled Enabled Jumper Position Definition Pins 1-2 Pins 2-3 Enabled Disabled