SBB 937R-E2JB User's Manual 1-2 SAS Expander The SBB 937R-E2JB includes two BMB-937-JB expanders, which are mounted on hot-swappable trays. The BMB-937-JB utilizes the LSISAS2x36, which is a 36-port, 6 Gb/s SAS expander. Cascading Each BMB-937-JB has a SAS-IN port and a SAS-OUT port, which in turn are con- nected to an I-SAS port at the rear of the chassis. The I-SAS port may then be used to cascade to another system (must be cascaded to a system with a proces- sor and memory). SAS The LSISAS2x36 is a x36 expander that provides SAS 2.0 support. RAID 0, 1, 10 and 1E modes. Refer to the following ftp site for setup guidelines:
micro.com/driver/SAS/LSI/LSI_SAS_EmbMRAID_SWUG.pdf> and Supermicro's web site for additional inmformation als/> (RAID is supported by third-party software.) 1-3 Server Chassis Features System Power The SC937 features a redundant Gold Level 700W power supply composed of two separate power modules. This power redundancy feature allows you to replace a failed power module without shutting down the system. SAS/SATA Subsystem The SC937 supports up to 16 3.5" SAS drives. These drives are hot-swappable units and are connected to a midplane that provides power and control. Notes:
The operating system connected to the SBB system must have RAID support to enable the hot-swap capability of the SAS drives. As an alternative to SAS drives, 3.5" SATA drives can be supported via an interposer (AOL-LSISS9252). Front Control Panel Two control panels are included on each end of the SBB 937R-E2JB to provide you with system monitoring and control. LEDs indicate system power, cascade status, 1-2