S UPER S ERVER 1015B-M3 User's Manual 5-7 PCI Expansion Cards Two riser cards are used to support add-on cards to the system. The chassis can accommodate one standard size (full height full length) and one low-profi le PCI expansion card (up to 5.5" long) in addition to a UIO card. When viewed from the chassis front, the standard size card installs to the left and the low-profi le card installs to the right side. PCI cards are installed into riser cards that have been pre-installed to the system. See confi guration list below. Installing a PCI Expansion Card Confi rm that you have the correct riser card for your chassis model and the 1. add-on card includes a standard bracket.
Remove the chassis cover. 2. Install the riser card by sliding card into the appropriate riser card in the moth- 3. erboard. For more information, see the riser card installation instructions. Choose the PCI slot shield in which to place the add-on card. 4. In that slot, open the PCI slot shield lever and slide the shield sideways. 5. From inside the chassis, remove the PCI slot shield. 6. Slide the add-on card into the riser card and attach the add-on card bracket 7. in place of the PCI slot shield. Secure the add-on card by closing the PCI slot shield lever. 8. Connect cables to the add-on card as necessary. 9.
PCI Slot/Card Confi gurations Right Side Riser Card Expansion card supported RSC-R1UU-E8 1x low-profi le PCI-E x8 card 5-10