Supermicro SuperServer 1015B-M3 — Supermicro SuperServer 1015B-M3 User's Manual PDF (Revision 1.0)

Chapter 5: Advanced Serverboard Setup 5-10 Jumper Settings Explanation of Jumpers To modify the operation of the serverboard, jumpers can be used to choose between optional settings. Jumpers create shorts between two pins to change the function of the con- nector. Pin 1 is identifi ed with a square solder pad on the printed circuit board. See the serverboard layout pages for jumper locations. 3 2 1 Connector Pins Jumper Setting 3 2 1 Note: On a two-pin jumper, "Closed" means the jumper is on both pins and "Open" means the jumper is either on only one pin or completely removed. CMOS Clear JBT1 is used to clear CMOS (which will also clear any passwords).

Instead of pins, this jumper consists of contact pads to prevent accidentally clearing the contents of CMOS. To clear CMOS, First power down the system and unplug the power cord(s). 1. With the power disconnected, short the CMOS pads with a metal object such 2. as a small screwdriver. Remove the screwdriver (or shorting device). 3. Reconnect the power cord(s) and power on the system. 4. Note: Do not use the PW_ON connector to clear CMOS. VGA Enable/Disable JPG1 allows you to enable or disable the VGA port. The default position is on pins 1 and 2 to enable VGA. See the table on the right for jumper settings.

5-19 VGA Enable/Disable Jumper Settings (JPG1) Jumper Setting Defi nition Pins 1-2 Enabled Pins 2-3 Disabled