Chapter 7: BIOS Option ROM Scan When enabled, this setting will initialize the device expansion ROM. The options are Enabled and Disabled. Enable Master This setting allows you to enable the selected device as the PCI bus master. The options are Enabled and Disabled. Latency Timer This setting allows you to set the clock rate for the Bus Master. A high-priority, high-throughout device may benefi t from a greater clock rate. The options are Default , 0020h, 0040h, 0060h, 0080h, 00A0h, 00C0h, and 00E0h. For the Unix, Novelle and other Operating Systems, please select the option: other.
If a drive fails after the installation of a new software, you might want to change this setting and try again. A different OS requires a different Bus Master clock rate . X I/O Device Confi guration Access the submenu to make changes to the following settings. KBC Clock Input This setting allows you to set a clock frequency for the KBC. The options are 6MHz, 8MHz, 12MHz, and 16MHz. Serial Port A This setting allows you to decide how Serial Port A will be controlled. The options are Enabled (user defi ned), Disabled, and Auto (BIOS- or OS- controlled). Base I/O Address This setting allows you to select the base I/O address for Serial Port A. The options are 3F8 , 2F8, 3E8, and 2E8.
Interrupt This setting allows you to select the IRQ (interrupt request) for Serial Port A. The options are IRQ3 and IRQ4 . Serial Port B This setting allows you to decide how Serial Port B will be controlled. The options are Enabled (user defi ned), Disabled, Auto (BIOS controlled) and OS Controlled. Mode This setting allows you to set the type of a device that will be connected to Serial 7-13