Supermicro 1018D-73MTF — SUPERSERVER 1018D-73MTF — User's Manual

Chapter 5: Advanced Motherboard Setup 5-5 Installing Memory Note: Check the Supermicro web site for recommended memory modules. CAUTION Exercise extreme care when installing or removing DIMM modules to prevent any possible damage. Installing DIMMs Insert the desired number of DIMMs into the memory slots, starting with the DIMMA1 slot. 1. Push the release tabs outwards on both ends of the DIMM slot to unlock it. 2. Align the key on the DIMM module with the receptive point on the slot. 3. Use two thumbs together to press both ends of the module straight down into the slot until the module snaps into place. 4. Press the release tabs to the lock positions to secure the DIMM module into the slot.

See Figure 5-4. Memory Support The X10SL7-F supports up to 32 GB of Unbuffered ECC DDR3-1600/1333 memory.. Figure 5-4. Installing DIMM into Slot Notch Notch To Install: Insert module vertically and press down until it snaps into place. Pay attention to the alignment notch at the bottom. Front View To Remove: Use your thumbs to gently push the release tabs near both ends of the module. This should release it from the slot. Release Tab Release Tab Note: Notch should align with the recep­ tive key point on the slot. Top View of DDR3 Slot 5-7