Supermicro 1018D-73MTF — SUPERSERVER 1018D-73MTF — User's Manual

S UPER S ERVER 1018D-73MTF User's Manual PCI-E Slot SMB Enable (I 2 C1/I 2 C2) Use Jumpers I 2 C1/I 2 C2 to enable PCI-E SMB (System Management Bus) support to improve system management for the PCI-E slots. See the table on the right for jumper settings. LAN Port Enable/Disable Use JPL1/JPL2 to enable or disable LAN Ports 1 and 2 on the motherboard. See the table on the right for jumper settings. The default setting is enabled. Backpanel USB Wake Up Enable Close pins 1/2 of jumper JPUSB1 to "wake up" the system when a device installed in USB 4 or USB 5 receives an incoming signal. See the table on the right for jumper settings.

Watch Dog Enable Watch Dog is a system monitor that can reboot the system when a software appli­ cation hangs. Close pins 1-2 of JWD1 to reset the system if an application hangs. Close pins 2-3 to generate a non-mask­ able interrupt signal for the application that hangs. See the table on the right for jumper settings. Watch Dog must also be enabled in the BIOS.

5-20 PCI-E Slot_SMB Enable Jumper Settings Jumper Setting Definition Pins 1-2 Enabled Pins 2-3 Disabled LAN Port En/Disable Jumper Settings Setting Definition Pins 1-2 Enabled Pins 2-3 Disabled Backpanel USB Wake Up Jumper Settings Jumper Setting Definition Pins 1-2 Enabled (Default) Pins 2-3 Disabled Watch Dog Jumper Settings Setting Definition Pins 1-2 Reset (default) Pins 2-3 NMI Open Disabled