Chapter 5: Advanced Motherboard Setup ME Recovery Set Jumper JPME1 to select ME Firm ware Recovery mode, which will limit system resource for essential function use only without putting restrictions on power use. In the single operation mode, online upgrade will be available via Re covery mode. See the table on the right for jumper settings. SAS Enable Jumper JPS1 allows the user to enable the onboard SAS connectors (L-SAS Ports 0-7). The default setting is 1-2 to enable the connection. See the table on the right for jumper settings.
Manufacturer Mode Select Close this jumper (JPME2) to bypass SPI flash security and force the system to use the Manufacturer mode which will allow the user to flash the system firmware from a host server to modify system settings. See the table on the right for jumper settings. 5-21 ME Recovery Jumper Settings Jumper Setting Definition Pins 1-2 Normal (Default) Pins 2-3 ME Recovery SAS Enable Jumper Settings Jumper Setting Definition Pins 1-2 Enabled (Default) Pins 2-3 Disabled ME Mode Select Jumper Settings Jumper Setting Definition Pins 1-2 Normal (Default) Pins 2-3 Manufacture Mode