Supermicro SuperServer 1019S-M2 — Explanation of Jumpers

Chapter 4: Motherboard Connections SuperServer 1019S-M2 User's Manual VGA Enable/Disable BMC Enabled JPG1 allows you to enable or disable the VGA port. The default setting is Enabled. JPB1 allows you to enable or disable the BMC (Baseboard Management Control) chip and the onboard IPMI connection. This jumper is used together with the IPMI settings in the BIOS. If the BMC is disabled, IPMI health monitoring and remote management functions are no longer supported. The default setting is BMC Enable. LAN1/2 Enable/Disable Change the setting of jumper JPL1 and JPL2 to enable or disable the LAN1 and LAN2 Ethernets ports, respectively. The default setting is Enabled.

Manufacturer Mode Select Close pins 2 and 3 of jumper JPME2 to bypass SPI flash security and force the system to operate in the manufacturer mode, which will allow the user to flash the system firmware from a host server for system setting modifications. The default setting is Normal. Watch Dog JWD1 controls the Watch Dog function. Watch Dog is a monitor that can reboot the system when a software application hangs. Jumping pins 1-2 will cause Watch Dog to reset the system if an application hangs. Jumping pins 2-3 will generate a non-maskable interrupt signal for the application that hangs. Watch Dog must also be enabled in BIOS. The default setting is Reset. Note:

When Watch Dog is enabled, the user needs to write their own application software to disable it. SMBus to PCI-E Slots Use jumpers JI 2 C1 and JI 2 C2 to connect the System Management Bus (I 2 C) to PCI-Express slots to improve PCI performance. These two jumpers should be set to the same setting. The default setting is Enabled.

53 52 VGA Enable/Disable Jumper Settings Jumper Setting Definition Pins 1-2 Enabled Pins 2-3 Disabled BMC Enable Jumper Settings Jumper Setting Definition Pins 1-2 BMC Enabled Pins 2-3 Disabled LAN1/2 Enable/Disable Jumper Settings Jumper Setting Definition Pins 1-2 Enabled Pins 2-3 Disabled Manufacturer Mode Jumper Settings Jumper Setting Definition Pins 1-2 Normal Pins 2-3 Manufacturer Mode Watch Dog Jumper Settings Jumper Setting Definition Pins 1-2 Reset Pins 2-3 NMI Open Disabled I2C for PCI-E Slots Jumper Settings Jumper Setting Definition Pins 1-2 Enabled Pins 2-3 Disabled