SuperServer 1019S-M2 User's Manual Chapter 6: BIOS Port 61h bit-4 Emulation Port 0 ~ Port 3 SATA Device Type Select Enabled to enable the emulation of Port 61h bit-4 toggling in SMM (System Management Mode). The options are Disabled and Enabled . Use this item to specify if the SATA port specified by the user should be connected to a Solid State drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State Drive. PCIe PLL SSC PCIe/PCI/PnP Configuration Enable this feature to reduce EMI interference by down spreading clock 0.5%. Disable this feature to centralize the clock without spreading. The options are Disabled and Enabled. The following information will display:
PCI Bus Driver Version SATA Configuration PCI Devices Common Settings: When this submenu is selected, the AMI BIOS automatically detects the presence of the SATA devices that are supported by the Intel PCH chip and displays the following items: PCI PERR/SERR Support SATA Controller(s) Select Enabled to allow a PCI device to generate a PERR/SERR number for a PCI Bus Signal Error Event. The options are Enabled and Disabled . This item enables or disables the onboard SATA controller supported by the Intel PCH chip. The options are Enabled and Disabled.
Above 4G Decoding (Available if the system supports 64-bit PCI decoding) SATA Mode Selection Select Enabled to decode a PCI device that supports 64-bit in the space above 4G Address. The options are Enabled and Disabled . Use this item to select the mode for the installed SATA drives. The options are AHCI and RAID. SATA Frozen PCH SLOT4 PCI-E 3.0 X4 (IN X8) Use this item to enable the HDD Security Frozen Mode. The options are Enabled and Disabled . Use this feature to select which firmware type to be loaded for the add-on card in this slot. The options are Disabled, Legacy , and EFI. *If the item above "SATA Mode Selection" is set to RAID, the following items will display:
CPU SLOT6 PCI-E 3.0 X16 Use this feature to select which firmware type to be loaded for the add-on card in this slot. The options are Disabled, Legacy , and EFI. SATA RAID Option ROM/UEFI Driver Select UEFI to load the EFI drvier for system boot. Select Legacy to load a legacy driver for system boot. The options are Legacy ROM and UEFI Driver. PCH SLOT 7 PCI-E 3.0 X4 (IN X8) Use this feature to select which firmware type to be loaded for the add-on card in this slot. The options are Disabled, Legacy , and EFI. SATA Port 0 ~ Port 3 This item displays the information detected on the installed SATA drive on the particular SATA port.
Onboard LAN Option ROM Type Model number of drive and capacity Select Enabled to enable Option ROM support to boot the computer using a network device specified by the user. The options are Legacy and EFI. Software Preserve Support Onboard LAN1 Option ROM Port 0 ~ Port 3 Spin Up Device Use this option to select the type of device installed in LAN Port1 used for system boot. The default setting for LAN1 Option ROM is PXE . On an edge detect from 0 to 1, set this item to allow the PCH to initialize the device. The options are Enabled and Disabled . Onboard LAN2 Option ROM Use this option to select the type of device installed in LAN Port2 used for system boot.
The default setting for LAN2 Option ROM is Disabled . 75 74