SuperServer 1019S-M2 User's Manual Chapter 6: BIOS PCH-FW Configuration COM1 Console Redirection Settings The following firmware information will display: ME FW Version This feature allows the user to specify how the host computer will exchange data with the client computer, which is the remote computer used by the user. COM1 Terminal Type ME Firmware Mode This feature allows the user to select the target terminal emulation type for Console Redirection. Select VT100 to use the ASCII Character set. Select VT100+ to add color and function key support. Select ANSI to use the Extended ASCII Character Set. Select VT-UTF8 to use UTF8 encoding to map Unicode characters into one or more bytes.
The options are VT100, VT100+ , VT-UTF8, and ANSI. ME Firmware Type ME Firmware SKU ME FW Image Re-Flash Use this feature to update the Mangement Engine firmware. The options are Enabled and Disabled . COM1 Bits Per second Use this feature to set the transmission speed for a serial port used in Console Redirection. Make sure that the same speed is used in the host computer and the client computer. A lower transmission speed may be required for long and busy lines. The options are 9600, 19200, 38400, 57600 and 115200 (bits per second). AMT Configuration Intel AMT COM1 Data Bits Select Enabled to use Intel AMT (Active Management Technology) to enhance system performance.
The options are Enabled and Disabled. Use this feature to set the data transmission size for Console Redirection. The options are 7 Bits and 8 Bits . BIOS Hotkey Pressed COM1 Parity Select Enabled to use the BIOS Hotkey feature. The options are Enabled and Disabled . A parity bit can be sent along with regular data bits to detect data transmission errors. Select Even if the parity bit is set to 0, and the number of 1's in data bits is even. Select Odd if the parity bit is set to 0, and the number of 1's in data bits is odd. Select None if you do not want to send a parity bit with your data bits in transmission. Select Mark to add a mark as a parity bit to be sent along with the data bits.
Select Space to add a Space as a parity bit to be sent with your data bits. The options are None , Even, Odd, Mark and Space. Watch Dog Select Enabled to allow AMT to reset or power down the system if the operating system or BIOS hangs or crashes. The options are Disabled , and Enabled. OS Timer / BIOS Timer These options appear if Watch Dog Timer (above) is enabled. This is a timed delay in seconds, before a system power down or reset after a BIOS or operating system failure is detected. Directly enter the value in seconds. COM1 Stop Bits A stop bit indicates the end of a serial data packet. Select 1 Stop Bit for standard serial data communication.
Select 2 Stop Bits if slower devices are used. The options are 1 and 2. Serial Port Console Redirection COM1 Flow Control COM1 Console Redirection Use this feature to set the flow control for Console Redirection to prevent data loss caused by buffer overflow. Send a "Stop" signal to stop sending data when the receiving buffer is full. Send a "Start" signal to start sending data when the receiving buffer is empty. The options are None and Hardware RTS/CTS. Console Redirection Select Enabled to enable console redirection support for a serial port specified by the user. The options are Enabled and Disabled .
COM1 VT-UTF8 Combo Key Support *If the item above set to Enabled, the following items will become available for user's configuration: Select Enabled to enable VT-UTF8 Combination Key support for ANSI/VT100 terminals. The options are Disabled and Enabled. 79 78